Section 04-04: Wheels and Tires
1993 Mustang Workshop Manual
ADJUSTMENTS

Aluminum Wheels

Tools Required:

 

Air Leaks

If the air pressure in an aluminum wheel is found to be low, the following procedure should be performed before considering wheel replacement.

  1. Remove the tire and wheel assembly, and inspect the wheel for structural damage. If none exists, go to Step 2. If the wheel is damaged, replace.
  1. With the tire mounted on the wheel, locate the air leak using a water bath or equivalent method, and mark the location. Check the complete wheel for possible additional leaks. When leaks are marked, dismount the tire marking valve location on the tire for proper indexing.
  1. On the tire side of the wheel, thoroughly clean the leaking area with Professional Choke and Linkage Cleaner E8AZ-19A501-AA (ESR-M14P10-A) or equivalent or use sandpaper of approximately 80-grit to remove all contamination. Using the sandpaper, score the surface of the wheel to improve adhesion of the sealer. Adequate area around the leak should be prepared to ensure covering the leak. If the valve stem is close to the area, remove it.
  1. Use a clean cloth to remove all cleaner or sanding dust.

    NOTE: Do not use a torch containing oxyacetylene.

  1. Heat the prepared area with Rotunda Electric Heat Gun 107-00300 or equivalent or propane torch until Hot Melt Sealant Stick E7AZ-19554-A (ESA-M4G280-A) flows. Apply the hot melt material over the prepared area using a liberal flow and wiping action to ensure coverage of the leaking area. Service is most effective when heat is applied to the brake side of the rim and sealer is melted by heat in the metal.


Tire Side of Wheel






Brake Side of Wheel




  1. Apply only enough heat to melt the sealer, then remove heat source. After servicing the leak, allow the wheel to cool until it can be handled safely.
  1. Index and assemble tire and wheel. Inflate tire to the recommended pressure as indicated on the tire pressure decal.

     CAUTION: Ensure tires with a symmetrical tread pattern are mounted as directed on the tire sidewall markings.

  1. Repeat Step 2 to verify service.

     CAUTION: Use care when mounting the tire so as not to damage the sealer.

  1. When the service is completed, balance the assembly and install on vehicle.