Window Motor

Removal

1. Raise the window to the full-up position, if possible. If the glass cannot be raised and is in a partially down position, it must be supported so that it will not fall into the door well during motor removal.

2. Disconnect battery ground cable.

3. Remove door trim panel and watershield. Refer to Section 01-05.

4. Disconnect window motor connector.

    CAUTION: Prior to motor removal, ensure that the regulator arm is in a fixed position to prevent counterbalance spring unwind.

5. Remove the three window motor mounting screws and disengage the motor and drive assembly from the regulator quadrant gear.

Installation

1. Install the motor and drive assembly. Tighten the retaining screws to 5.6-9.6 Nm (4-7 lb-ft).

2. Connect the motor wiring connector. Check window for proper operation.

   NOTE: Appropriate plug buttons may be installed to cover the exposed hole at the trim panel edge, if necessary.

3. Install the door trim panel and watershield. Refer to Section 01-05.

4. Connect battery ground cable.

5. Check the drain holes at the bottom of the doors to ensure that each is open to prevent water buildup over the motor.