The interior trim component Removal and Installation procedures generally apply to all models. If some of the Steps do not apply to the particular models being serviced, proceed to the next Step.

Trim Panel, Package Tray

2-Door

Removal of the rear seat cushion and rear seat back assembly is necessary on all models for replacement of the package tray trim panel. Refer to Section 01-10A for rear seat cushion and seat back removal and installation procedures. On all models it will be necessary to remove the body side quarter trim panels.

Removal

1. Remove high-mount stoplamp. Refer to Section 17-01.

2. Remove safety belt retractor covers, retractors and retainer assembly. Refer to Section 01-20A.

3. Remove quarter trim panels as outlined.

4. Remove the trim panel retaining screws and push pin.

5. Pull the trim panel slightly upward and forward and remove it from the package tray.
   
   
   
   

Installation

1. Position trim panel and install retaining screws and push pin.

2. Install quarter trim panels as outlined.

3. Install safety belt retainer assembly, retractors and retractor covers. Refer to Section 01-20A.

4. Install the rear seat back and seat cushion.

5. Install high-mount stoplamp. Refer to Section 17-01.