CAUTION: Never apply heat to the bumper energy absorbers. Heat could cause the material inside the absorbers to expand and flow out of the absorbers or crack the metal housing. Always remove the absorbers before performing body frame service near them.

 CAUTION: Never apply excessive heat to bumper surface. Heat could cause the bumper to distort.

 CAUTION: When collecting exhaust fumes in service area, never attach a metal collector to the exhaust tail pipe as the heat could damage the bumper.

Body Misalignment Check

 CAUTION: Do not attempt to correct any serious misalignment with one jacking operation.

To align or square up a body, take two opposite diagonal measurements between the front, center or rear pillars. Take the measurements between reference points, such as crease lines or weld joints which are diagonally opposite each other, on the two pillars being measured. Since all measurements should be made from the bare metal, remove all interior trim from the checking points.

Align each section proportionately, until the proper dimensions are obtained. Refer to the following underbody dimensions.