Procedure 1—Substrate Cuts or Cracks (Substrate Material Not Removed)

1. Wipe repair area with silicone and wax remover, to ensure clean surfaces.

2. Apply a thin coating of 414-Adhesive D7AZ-19554-C (ESA-M2G140-A1) or equivalent to one surface of the cut or crack. Position the surfaces very carefully together in their original position. Quickly and firmly press the two surfaces together for at least one minute. Good bond strength is developed after one minute but maximum strength requires 3 to 12 hours cure time. Note the precautions on adhesive container.

3. If the part did not have paint damage and the part was properly positioned, painting may not be required. However, if painting is necessary, proceed as follows:

   NOTE: Elastomeric additive is for industrial use only by qualified personnel. It is not intended for the general public.

   1. Scuff-sand the repair area with a sanding block and No. 400 paper. Be careful not to sand through the color coat surface. Usually dulling the surface is sufficient. Wipe off or clean the repair area with a clean, dry cloth or an air gun.
   2. Wipe the sanded surface with silicone and wax remover or equivalent.
   3. Refinish as described under Refinishing Flexible Exterior Parts.