Color Coat

As the complete coated area, as well as the upper raw edge, must be covered with color coat, mask off the upper margin line using the Fine Line Tape positioned 1.59mm (1/16 inch) above coating edge. Using appropriate repair paint and application procedures (to include both prime and color coat), the protective coating area can now be finish painted.

NOTE: If damaged sheet metal extends above the protective coating area, normal prime/color paint procedures should be followed.

Materials Required

• Abrasion Resistant Coating D9AZ-19515-A (ESB-M4G221-A).
• Multi-Purpose Paint Precleaner (Spray Gun Clean-Up) VC-542-A.
• Scotch Fine Line Tape (3M Part No. 06303—1/2 inch x 60 yards).

Suggested Equipment

• DeVilbiss Spray Gun model JGA-502-704-FX (Rotunda Spray Gun 085-01626 or equivalent).
• DeVilbiss Remote Pressure Cup model KB-520 (1.89L (2 quarts), KB-521 0.946L (1 quart) or Rotunda Detached Pressure Cup 085-01617 1.89L (2 quarts) or equivalent).
• Binks Spray Gun model 62 (No. 63 Air Cap, No. SS Fluid Tip, No. 363 AN Needle) or equivalent.
• Binks Attached Pressure Cup model 80 0.946L (1 quart) (with Air Adjusting Gauge) or equivalent.
• Rotunda Heat Gun 107-00300 or equivalent, Rotunda Dual Action Air Sander 107-01619 or equivalent.